Innokin Kroma Z cartridge
The Innokin Kroma Z cartridge is used exclusively with the Kroma Z kit. With its 4.5 ml capacity, it ensures long hours of uninterrupted vaping. The cartridge is filled through the outer lid without removing it from the kit.
The ring that holds the coil in place acts as an airflow. Its 3 feed holes allow airy draw.
Practical, it uses all the Z coil resistances that have already proved their worth. This kit includes 2 resistances:
- 1 Innokin Z Coil 0.3 ohm resistance, in restrictive direct draw, for use between 30 and 40 W.
- 1 Innokin Z Coil 0.8 ohm resistance, in indirect draw, for use between 15 and 18 W.
Sold individually
E-liquid not included: complete your purchase with e-liquid.
For a first purchase, we advise you to test several different liquids, for example at least one Classic flavour and at least one fruity flavour.
- Fill your cartridge:
Pull on the cartridge drip to remove it from the pod. Lift the Teflon cover on the side of the cartridge and fill it. Then put the cartridge back in place.
- Change the coil :
Pull on the drip of the cartridge to remove it from the pod. Unscrew the ventilation ring and remove the defective coil. Replace with a new one.
- Adjust the Airflow :
Pull on the cartridge drip to remove it from the pod. Turn the adjustment knob at the bottom of the cartridge to the right or left depending on the type of vape you are looking for. Replace the cartridge.
- We suggest you put a few drops of e-liquid on the cotton part of your coil. This will prevent a burnt taste.
- Make sure you respect the maximum usage ranges indicated on your coils.