Vaporesso Forz RDA dripper

Vaporesso Forz RDA dripper

Vaporesso presents Forz, a dripper designed for powerful, intense vaping. Vaporesso has pulled off a real tour de force with its precision work to bring out all the aromatic notes, even the most subtle, in your liquids.

Top part of the disassembled

The atomisation chamber is large and well designed. It is topped by a short, wide 810 drip tip for DL use.

Honeycomb airflow

The airflow is integrated into the bell without any interfering play. You can choose between a honeycomb pattern or a wide slot for maximum airflow. You can separate the bell from the top cap for optimum cleaning of your equipment. Versatile, with a 24 mm diameter, it fits most boxes and LF boxes on the market.

Forz RDA mounting plate

The mounting plate is wide and accessible. 4 studs are available for double-coil mounting. The bell's width and height mean it can accommodate large, complex assemblies. The clamping screws are easily accessible and the holes are large enough to accommodate thick thread.

A hollow 510 pin is supplied with the kit to enable you to mount your Forz dripper on a BF box. When used as a bottom feeder, the liquid is fed in from the sides rather than from under the coil, ensuring that the cotton is well impregnated.

Dripper Forz RDA complete kit

Calumette's review: A well-designed dripper that's easy to use. It will reveal all its potential when setting up coils with very low values.

E-liquid not supplied: Complete your purchase with e-liquid.
For a first purchase, we advise you to test several different liquids, for example at least one Classic flavour and at least one fruity flavour.

Advantages

• Dual coils
• 24 mm diameter
• BF compatible

Kit contents

• 1 Vaporesso Forz RDA dripper
• 1 spare O-rings kit
• 1 flat screwdriver
• 2 sets of flathead screwdrivers
• 1 BF 510 pin
• 1 Allen key
• 1 drip tip 510/810 adaptor
• 1 drip tip 810
• 2 pre-assembled coils
• 1 user manual

Specifications

• Length: 3.2 cm
• Diameter : 2.4 cm
• Weight: 40 g
• Capacity: no capacity on a dripper
• 510 screw thread
• 810 drip tip
• Assembly: double coils
• Metal bell
• Compatible with coils: rebuildable coil
• Inhalation type: direct
• vapor type: airy
• vapor: warm to hot
• Percentage of VG in liquid for optimum use: ≤ 90% Vegetable Glycerin
• Level: expert

Use

Pull on the atomisation bell to access the base of the plate. Unscrew the plate screws using the screwdriver supplied.

Place your coils on the plate and tighten the screws. Carefully cut a piece of wick about 0.5 cm long, and roll it around to place it in the centre of each coil.

Redirect the wicks to the side of each coil and trim the excess so that the cotton does not protrude from the plate. Cut the coil threads that stick out flush with the mounting studs. Soak your cotton well before closing your clearomizer. Now all you have to do is fill it up and vape!

We advise you to check the ohm resistance of each of your coils with an ohm meter. A too low coil or a short circuit can seriously damage your equipment.

Advice

- We suggest you try several different threads and cottons to find your ideal vape. Bear in mind that the thinner the thread, the higher the resistance and vice versa.