Innokin Sceptre 2 cartridge

Innokin Sceptre 2 cartridge

Replacement cartridge strictly compatible with the Innokin Sceptre 2 pod.

The cartridge is filled from the side by lifting the Teflon cover. Airflow is adjusted using a sliding knob, rather than the bottom of the cartridge. The choice is yours: a tighter draw for indirect inhalation or a more airy draw for restrictive direct inhalation.

The cartridge can be used with Innokin S coil or Innokin Sceptre resistances, so that every vaper can find their own type of vape.

Please note: the coil is mounted on an adaptor, so make sure you keep it in a safe place when you change the resistance.

2 types of coil are included in the kit:

• Innokin Sceptre 0.6 ohm resistance with an operating range of 11 W to 16 W for indirect to restrictive direct inhalation.
• Innokin Sceptre S Coil 0.5 ohm resistance with an operating range of between 18 W and 20 W for restrictive direct inhalation vaping.

Sold individually

Use

- Fill the cartridge:
Pull on the cartridge drip to remove it from the pod. Lift the Teflon side cover and fill it. Then put the cartridge back in place.

- Change the coil :
Pull on the cartridge drip to remove it from the pod, then pull on the coil support. Unscrew the coil and fit a new one. Replace the whole assembly in the cartridge.

- Adjuste the Airflow :
Slide the knob on the cartridge to obtain a more or less airy draw.