Hellvape Dead Rabbit 3 RDA New Color dripper

Hellvape Dead Rabbit 3 RDA New Color dripper

Hellvape Dead Rabbit 3 RDA Dripper

The ever-popular Dead Rabbit from Hellvape is back in a V3 version! The overall design of the Dead Rabbit 3 features the emblematic rabbit engraved on the atomisation bell.

Disassembled dripper bell

The whole dripper is perfectly machined and fitted, with no interfering play during disassembly. The bell is in 2 parts for easy cleaning. The bell features a 2-position rotary airflow: wide slot or honeycomb for an airy draw.

Honeycomb airflow for a precise draw

The ring is tight enough not to go out of adjustment, but not too tight to ensure smooth operation.

Removable 810 drip tip

The Dead Rabbit is topped by a short, wide 810 drip tip for a totally airy, direct draw.

Dead Rabbit 3 mounting plate

The mounting plate is based on version 2 of the Dead Rabbit. Assembly is still relatively simple. The 24 mm width of the plate makes it easy to fit even 2 large coils. The dripper comes with a BF pin, which supplies liquid to your Dead Rabbit if you have a BF box. The liquid is then distributed through 2 holes on each side of the coils, optimising the humidification of your cotton.

HellVape Dead Rabbit 3 complete kit

Calumette's review: The Dead Rabbit 3 is an excellent dripper that will delight you with its excellent flavour reproduction and ease of use on a daily basis. You'll be able to use double coils for a powerful vape.

E-liquid not included: Complete your purchase with e-liquid.
For a first purchase, we advise you to test several different liquids, for example at least one Classic flavour and at least one fruity flavour.

Advantages

• Dual-coil assembly
• BF compatible
• Quality of manufacture
• Excellent flavour reproduction

Kit contents

• 1 HellVape Dead Rabbit 3 RDA dripper
• 1 O-rings kit
• 1 set of Allen keys
• 1 flathead screwdriver
• 4 replacement screws
• 2 cotton wicks
• 2 Fused Clapton Ni80 0.37 ohm coils
• 1 BF pin
• 1 user manual

Specifications

• Length: 3.2 cm
• Diameter : 2.4 cm
• Weight: 41 g
• Capacity: no capacity on a dripper
• 510 thread
• 810 drip tip
• Assembly: double coil
• Stainless steel atomisation bell
• Compatible with coils: rebuildable coil
• Inhalation type: direct
• vapor type: airy
• vapor: cold to hot
• Percentage of VG in liquid for optimum use: ≤ 90% Vegetable Glycerin
• Level: expert

Use

- Placing your coils:
Unscrew the base of the atomizer to access the base of the plate. Unscrew the plate screws using the screwdriver supplied.

Cut the coil threadss using the template supplied. Place your coils on the plate and tighten the screws. Carefully cut a piece of cotton about 0.5 cm long and roll it up to fit in the centre of the coil.

Redirect the wicks on either side of the coils and trim the excess so that the cotton does not protrude from the plate. Soak your cotton well before closing your atomizer/dripper. Now all you have to do is fill it up and vape!

We advise you to check the resistance in ohms of each of your coils with an ohm meter. A too low coil or a short circuit can seriously damage your equipment.

Advice

- We suggest you try several different threads and cottons to find your ideal vape. Bear in mind that the thinner the thread, the higher the resistance and vice versa.