Oumier Wasp Nano RDA Plus dripper

Oumier Wasp Nano RDA Plus dripper

Oumier Wasp Nano RDA Plus Dripper

Oumier is an e-cigarette manufacturer that offers equipment for beginners and also for more expert users. The 24 mm diameter Oumier Wasp Nano Plus RDA dripper is a simple, effective model with a modern design.

Wide or honeycomb airflow

An adjustable wide slot or honeycomb airflow supplies air to your dripper for a tighter or airy draw. The air supply is classic, it goes over the coil and accentuates the mixing of the flow.

Wasp Nano Plus atomisation bell, disassembled

The airflow is removed by unscrewing the top ring. An 810 drip tip on top provides a powerful airflow.

Double-coil assembly with 45° tilted studs

On the base, a wide plate with 45° inclined studs provides easy access to the clamping screws. This means that two coils can sit side by side for excellent vaping.

The Wasp Nano Plus dripper comes with a 510 BF pin for adapting to a Bottom Feeder box.

Oumier Wasp Nano RDA Plus complete kit

Calumette's review: A compact dripper that's easy to use. It's perfect for anyone new to the vast world of drippers.

E-liquid not included: Complete your purchase with e-liquid.
For a first purchase, we advise you to test several different liquids, for example at least one Classic flavour and at least one fruity flavour.

Advantages

• Dual-coil assembly
• BF compatible
• Precise airflow
• Easy to use
• Excellent flavour reproduction

Kit contents

• 1 Dripper Oumier Wasp Nano RDA Plus
• 1 O-rings kit
• 1 flat screwdriver
• 4 replacement screws
• 2 cotton wicks
• 2 0.28 ohm coils
• 1 BF pin
• 1 user manual

Specifications

• Length: 3.1 cm
• Diameter : 2.4 cm
• Weight: 36 g
• Capacity: no capacity on a dripper
• 510 BF compatible screw thread
• 810 drip tip type
• Assembly: double coil
• Stainless steel atomiser bell
• Compatible with coils: rebuildable coil
• Inhalation type: direct
• vapor type: airy
• vapor: cold to hot
• Percentage of VG in the liquid for optimum use: ≤ 90% Vegetable Glycerin
• Level: expert

Use

- Placing your coils:
Unscrew the base of the atomizer to access the base of the tray. Unscrew the tray screws using the screwdriver supplied.

Cut the coil wires using the template supplied. Place your coils on the tray and tighten the screws. Carefully cut a piece of cotton about 0.5 cm long and roll it up to fit in the centre of the coil.

Redirect the wicks on either side of the coils and trim the excess so that the cotton does not protrude from the tray. Soak your cotton well before closing your atomizer/dripper. Now all you have to do is fill it up and vape!

We advise you to check the resistance in ohms of each of your coils with an ohm meter. A too low coil or a short circuit can seriously damage your equipment.

Advice

- We suggest you try several different threads and cottons to find your ideal vape. Bear in mind that the thinner the thread, the higher the resistance, and vice versa.