Hellvape Dead Rabbit V3 RTA atomizer

Hellvape Dead Rabbit V3 RTA atomizer

Dead Rabbit V3 complete atomizer

Hellvape presents the RTA version of the Dead Rabbit V3. Despite its imposing size (26 mm in diameter), its modern design is refined. The finish and fit are perfect, with no interfering play. The engravings are visible, with the rabbit characteristic of the range.

Atomizer disassembled

The tank capacity is adjustable: 3.5 ml or 5.5 ml with the tank glass bulb. You'll have more autonomy.

Removable top cap and filler slots

The removable quarter-turn top cap gives access to two large filling inlets suitable for all types of bottle. An 810 drip tip tops the assembly for an airy, direct draw.

Adjustable airflow

An adjustable airflow under the top cap controls the airflow and limits any leaks.

Mounting plate

Unscrew the base of the Dead Rabbit to access the double-coil mounting plate. Hellvape has abandoned its rabbit-ear shaped plate in favour of a more conventional 'postless' plate. The coils are easy to fit for everyday use. The width of the plate means you can fit large coils without any difficulty.

Atomizer ventilation grille

Underneath the airflow, a grille provides ventilation under and to the sides of the coils. Flavour reproduction is excellent.

Hellvape Dead Rabbit V3 complete atomizer kit

Calumette's review: What can I say? Hellvape is upgrading its famous Dead Rabbit, and the results are more than positive in terms of autonomy, mounting plate and airflow....A great performance for Hellvape that will not leave you indifferent.

E-liquid not included: Complete your purchase with e-liquid.
For a first purchase, we advise you to test several different liquids, for example at least one Classic flavour and at least one fruity flavour.

Advantages

• Dual-coil assembly
• 5.5 ml capacity
• Quality of manufacture
• Excellent flavour reproduction

Kit contents

• 1 HellVape Dead Rabbit 3 RTA atomizer
• 1 O-rings kit
• 1 Allen key
• 1 flathead screwdriver
• 4 replacement screws
• 1 tank glass 5.5 ml
• 2 cotton wicks
• 2 Fused Clapton Ni80 0.37 ohm coils
• 1 instruction leaflet

Specifications

• Length : 4.6 cm
• Diameter : 2.6 cm
• Weight : 59 g
• Capacity: 3.5 ml to 5 ml
• 510 screw thread
• 810 drip tip
• Assembly: double coil
• Stainless steel spray bell
• Compatible with coils: rebuildable coil
• Inhalation type: direct
• vapor type: airy
• vapor: cold to hot
• Percentage of VG in liquid for optimum use: ≤ 90% Vegetable Glycerin
• Level: expert

Use

- Placing your coils:
Unscrew the base of the atomizer to access the base of the plate. Unscrew the plate screws using the screwdriver supplied.

Cut the coil threads using the template supplied. Place your coils on the plate and tighten the screws. Carefully cut a piece of cotton about 0.5 cm long and roll it up to fit in the centre of the coil.

Redirect the wicks on either side of the coils and trim the excess so that the cotton does not protrude from the plate. Soak your cotton well before closing your atomizer. Now all you have to do is fill it up and vape!

We advise you to check the resistance in ohms of each of your coils with an ohm meter. A too low coil or a short circuit can seriously damage your equipment.

Advice

- We suggest you try several different threads and cottons to find your ideal vape. Bear in mind that the thinner the thread, the greater the resistance, and vice versa.