Innokin Go Z kit
Innokin Go Z
Back to minimalism with the Innokin Go Z kit: a kit that's discreet and easy to use. Its modern, unadorned design reflects its use.
Ignition button and 510 screw thread for a small diameter of 20 mm
The round battery has an ignition button. There are no settings, the battery is automatic. It reaches a maximum power of 16W depending on the coil selected, with a capacity of 1500 mAh. Charging is by micro USB plug.
The power button lights up to indicate the battery's charge level.
Innokin Go Z battery and clearomizers
The battery is topped by a Go Z clearomizer made from food-grade PCTG. This material makes the clearomizer highly shock-resistant.
Filling via sliding top cap
Filling is via a sliding top cap, an ingenious system that's rather rare for this type of equipment. The whole thing fits snugly and doesn't feel loose when in use.
Adjustable airflow Innokin Go Z clearomizer
The base of the clearomizer houses an airflow ring specially designed for a tight draw and indirect inhalation. Once again, there's no play and adjustment is disconcertingly simple.
Clearomizer disassembled with Innokin Z coil 1.6 ohm
Under this ring are the Innokin Z coil 1.6 ohm designed for indirect vaping. These have already proved their worth on other Innokin clearomizers such as the Zenith and Zlide. Coils that have the art and manner to sublimate all your flavours.
Innokin Go Z complete kit
Calumette's review: An excellent starter kit with which you can vape all types of liquids, whether classic nicotine, nicotine salts or CBD.
E-liquid not included: Complete your purchase with e-liquid.
For a first purchase, we advise you to test several different liquids, for example at least one Classic flavour and at least one fruity flavour.
- Switching on/off your Innokin Go Z Kit:
Perform 5 consecutive presses on the swich.
- Recharging your Go Z battery:
Plug the micro USB cable into your computer's USB port or wall socket. The LED flashes while charging and goes out once charged.
Charge indicator after each puff :
- Filling your clearomizer:
Slide back the top cap and fill by introducing the e-liquid along the inside walls of the clearomizer. Then close.
- Changing the coil :
Unscrew the base of the tank and pull on the coil. The coil is not screwed on but clipped onto the clearomizer. Remember to change your coils every 10 to 15 fills. The clearomizer must be empty when changing the coil.
- Adjusting the Airflow :
Turn the Airflow ring to adjust the airflow to your liking. The ring allows you to block the holes through which the air enters the clearomizer to a greater or lesser extent. The more the holes are open, the more the vapor. In short, for a tight draw, leave the air holes almost closed and for a more airy draw, leave the air holes wide open.
- We suggest you put a few drops of e-liquid on the cotton part of your Innokin Z coil. This will prevent a burnt taste.
- Be sure to respect the maximum use ranges indicated on your coils.