Geek Vape Z RDA dripper

Geek Vape Z RDA dripper

Geek Vape Z RDA dripper

The Z RDA dripper follows in the footsteps of the Zeus range. The finish is impeccable. The range is easily identifiable by its famous stamp evoking the God Zeus from Greek mythology.

Airflow at the top of the dripper

The atomisation bell is slim and cut from the mass. The airflow at the top of the bell provides ventilation for the coils while preventing the liquid from leaking.

Removable top section

The dripper is topped by an 810 drip tip for powerful, direct vaping. The airflow ring and drip tip are removable, making it easy to clean the various components of your dripper.

The double-coil mounting plate is cut from solid material. It's relatively easy to fit, given the diameter of the plate. The screws on the sides of the studs are easily accessible and allow the coils to be tightened securely.

Dual-coil plate for direct, powerful vaping

The plate's tank holds just a few millilitres of liquid, which is appreciable in everyday use. In the absence of the perforated 510 pin, the Geek Vape Z RDA dripper cannot be used as a bottom feeder, but this is more than made up for by the capacity of the tank and the airflow.

The turnkey kit comes with 2 double fused clapton 0.40 ohm coils and 4 cotton wicks for your own assembly.

Geek Vape RDA Z complete dripper kit

Calumette's review: An excellent dripper, simple in its design but which proves to be efficient and effective.

E-liquid not included: Complete your purchase with e-liquid.
For a first purchase, we advise you to test several different liquids, for example at least one Classic flavour and at least one fruity flavour.

Advantages

• Dual coil
• Top-mounted airflow
• Powerful, intense vapor

Kit contents

• 1 Geek Vape RDA Z dripper
• 2 Fused Clapton 0.40 ohm coils
• 4 cotton wicks
• 1 coil template
• 1 Ultem 810 drip tip adaptor
• 2 sets of flathead screwdrivers
• 1 3-prong screwdriver
• 1 spare O-rings kit
• 1 user manual

Specifications

• Length: 2.9 cm
• Diameter: 2.5 cm
• Weight: 33 g
• Capacity: no capacity on a dripper
• 510 screw thread
• Type 810 drip tip
• Assembly: double coil
• Stainless steel atomisation bell
• Compatible with coils: rebuildable coil
• Inhalation type: direct
• vapor type: airy
• vapor: cold to hot
• Percentage of VG in liquid for optimum use: ≤ 90% Vegetable Glycerin
• Level: expert

Use

- Placing your coils:
Unscrew the base of the atomizer to access the base of the plate. Unscrew the plate screws using the screwdriver supplied.

Cut the coil threads using the template supplied. Place your coils on the plate and tighten the screws. Carefully cut a piece of cotton about 0.5 cm long and roll it up to fit in the centre of the coil.

Redirect the wicks on either side of the coils and trim the excess so that the cotton does not protrude from the plate. Soak your cotton well before closing your atomizer/dripper. Now all you have to do is fill it up and vape!

We advise you to check the resistance in ohms of each of your coils with an ohm meter. A too low coil or a short circuit can seriously damage your equipment.

Advice

- We suggest you try several different threads and cottons to find your ideal vape. Bear in mind that the thinner the thread, the higher the resistance and vice versa.