Geek Vape Talo X RDA dripper

Geek Vape Talo X RDA dripper

The Talo X may be a relatively classic dripper, but it's still a great value that fits many mods and BF boxes. With its 24mm diameter, the Talo X combines a compact size with sufficient width for building coils. It comes in 3 parts: a top cap, an atomisation bell and a mounting plate.

Removable top cap for airflow adjustment

The airflow can be precisely adjusted to 3 positions: wide, medium or tight. The whole unit is perfectly machined, so there's no play when you're handling it. The Ultem 810 drip tip sets the tone for powerful direct vape with character.

X-shaped mounting plate

The mounting plate is cut from solid. X-shaped contact studs make it easy to fit a single or double coil. The negative studs are also cut from the same material, giving body and strength to the assembly. The coil is easy to fit.

Thanks to its 510 BF pin, the Talo can be converted into a BF dripper. The liquid is fed under the coil or coils, but not directly onto them.

Geek Vape Talo X RDA complete kit

Calumette's review: The Talo X dripper is easy to assemble as a single or double coil. It's compatible with Botton Feeding. Its value for money is unbeatable. What more could you ask for in a rebuildable?

E-liquid not included: Complete your purchase with e-liquid.
For a first purchase, we advise you to test several different liquids, for example at least one Classic flavour and at least one fruity flavour.

Advantages

• Single coil Dual coil
• 3-position airflow
• X-shaped plate for easy assembly

Kit contents

• 1 Geek Vape Talo X RDA dripper
• 1 spare O-rings kit
• 2 sets of flat head screwdrivers
• 1 BF 510 pin
• 1 3-prong screwdriver
• 1 coil template
• 1 510/810 drip tip adaptor
• 2 Fused Clapton 0.40 ohm coils
• 4 cotton wicks
• 1 user manual

Specifications

• Length : 2.7 cm
• Diameter : 2.4 cm
• Weight: 37 g
• Capacity: no capacity on a dripper
• 510 screw thread
• 810 drip tip
• Assembly: double coil or single coil
• Stainless steel atomisation bell
• Compatible with coils: rebuildable coil
• Inhalation type: direct
• vapor type: airy
• vapor: cold to hot
• Percentage of VG in liquid for optimum use: ≤ 90% Vegetable Glycerin
• Level: expert

Use

- Placing your coils:

Unscrew the base of the atomizer to access the base of the plate. Unscrew the plate screws using the screwdriver supplied.

Cut the coil threads using the template supplied. Place your coils on the plate and tighten the screws. Carefully cut a piece of cotton about 0.5 cm long and roll it up to fit in the centre of the coil.

Redirect the wicks on either side of the coils and trim the excess so that the cotton does not protrude from the plate. Soak your cotton well before closing your clearomizer. Now all you have to do is fill it up and vape!

We advise you to check the resistance in ohms of each of your coils with an ohm meter. A too low coil or a short circuit can seriously damage your equipment.

Advice

- We suggest you try several different threads and cottons to find your ideal vape. Bear in mind that the thinner the thread, the higher the resistance and vice versa.