Geek Vape RBA Aegis Boost 2ml cartridge

Geek Vape RBA Aegis Boost 2ml cartridge

The Geek Vape RBA Aegis Boost cartridge lets you turn your pod into a real rebuildable. Made up of a single coil plate, you'll find it easy to assemble.

Assembly plate and Teflon filling lid

With a capacity of 2 ml, it's easy to fill via the Teflon lid above the airflow, like all Aegis boost cartridges. The posts with springs make it easy to insert the coils. The kit comes complete with a ready-to-use kit.

Complete Geek Vape RBA Aegis Boost kit

Specifications

• 2 ml capacity
• Compatible exclusively with the Geek Vape Aegis Boost kit
• 2 Kanthal 1.3 ohm resistances
• 2 N80 fused Clapton coils 0.6 ohm
• 1 tight drip tip for indirect draw
• 2 replacement screws
• 2 replacement springs
• 4 cotton wicks
• 1 screwdriver
• 1 instruction leaflet

Use

- Unscrew the screws on the plate using the screwdriver supplied.
- Place your coils on the plate and tighten the screws.
- Carefully cut a wick about 0.5 cm long, then roll it around to place it in the centre of the coil.
- Redirect the wicks towards the inside of the plate and trim the excess so that the cotton does not protrude from the plate.
- Cut any coil threads that are higher.
- Soak your cotton well before closing your plate.
- Now all you have to do is fill it up and vape!