Voopoo ITO X cartridge

Voopoo ITO X cartridge

The ITO-X cartridge is used with the Voopoo Drag Q kit. Made from steel and PCTG, it is drop and heat resistant. The long, narrow proprietary drip tip enables indirect inhalation. A second, shorter drip tip is supplied for a slightly more airy draw.

The top cap unscrews to reveal a Teflon anti-drip filler hole. The cartridge is held in the pod by spring-mounted balls, which prevent the cartridge from detaching from the battery if dropped. Unlike the magnet system, this will require a little more energy to remove the cartridge from the pod.

Voopoo ITO coils are inserted from the bottom of the cartridge. You can choose between 3 types of resistance:

• Voopoo ITO M3 1.2 ohm resistance with an operating range of between 8 W and 12 W for indirect inhalation. Suitable for beginners and high nicotine strengths.
• Voopoo ITO M2 1 ohm resistance with an operating range of 10 W to 14 W for indirect inhalation. Suitable for beginners and high nicotine strengths.
• Voopoo ITO M0 0.5 ohm resistance with an operating range of 18 W to 25 W for direct restrive inhalation. Suitable for airy vaping.

Sold individually

Use

- Fill your cartridge:
Turn the top cap a quarter turn and pour the e-liquid through the filler hole provided. Then close.

- Change the coil :
Pull on the cartridge drip to remove it from the pod. Remove the coil and replace it. Put the cartridge back in place.